MATERIAL SAFETY DATA SHEET

Manufacturer's Name:

MULTICOAT CORPORATION
23061 ARROYO VISTA
RANCHO STA. MARGARITA, CA 92688 

Date prepared or revised:
June 28, 2000

Information Telephone No
949-888-7100

 

SECTION I - PRODUCT IDENTIFICATION

Chemical name:
MULTI-TEX STUCCO MIX

 

SECTION II - HAZARDOUS INGREDIENTS

May contain the following:
CHEMICAL NAME CAS NUMBER

EXPOSURE LIMITS IN AIR (Give Units)
ACGIH TLV     OSHA     PEL      OTHER

Ammonia
Propylene Glycol
Preservative  
Coalescent
7664-41-7
57-55-6
4080-31-3
25265-77-4

25 ppm
NE
NE
NE

50 ppm

 

SECTION III - PHYSICAL DATA

Melting Point/Freezing Point: Boiling Point: Specific Gravity (Water = 1):
0C/32F (Water) 100C/212F (Water) 1.6 to 1.8.
Evaporation Rate (Butyl Acetate = 1): Solubility in Water: Vapor Pressure:
Less than 1 (Water) Dilutable Aqueous Dispersion 7mm Hg @ 20C/68F

Appearance and Odor:
White or colored plaster, mild ammoniacal or acrylic odor.
 

SECTION IV - FIRE AND EXPLOSION HAZARD DATA

Flash point: Not Applicable

Auto Ignition Temperature: Not applicable

Extinguishing Media: Material is not combustible. Use Water.

Splatter:
The wet dispersion will splatter above 100C/212F (Boiling point of water).

Special Firefighting Procedures:
Firefighters should be equipped with self-contained breathing apparatus and full protective gear.

 

SECTION V - HEALTH HAZARD DATA

ROUTE(S) OF ENTRY:

Inhalation - Vapor or mist can cause headaches, nausea, and irritation of the nose, throat and lungs.

Skin Contact - May be irritating upon repeated or prolonged contact. Wash skin with soap and water after contact.

Eye Contact - Flush eyes with large amount of water for at least 15 minutes. Consult physician if irritation persists.

HAZARD RATING (NFPA 704)

HEALTH EFFECTS

The effects of over-exposure are based on acute toxicity profiles for a number of acrylic emulsions that are compositionally similar to the binder used in this product.
Typical values are: Rate, oral LD50:
Rabbit, dermal LD 50
Rabbit
>5.0 g/kg
>5.0 g/kg
Eye irritation
Acute effects:
Chronic effect:   
Non-toxic by ingestion. May cause eye and skin irritation
No known chronic health effects
FIRST AID/EMERGENCY PROCEDURES

Eye Contact:
Flush eyes immediately with running water for 15 minutes, including under eyelids. Consult a physician if irritation persists.

Skin Contact:
Wash with soap & water.

Inhalation:
Move subject to fresh air. If breathing is difficult consult a physician.

Ingestion:
Dilute with large amounts of water and consult physician.

SUSPECTED CANCER AGENT?
NO    This product's ingredients are not found in the Federal OSHA, NTP, IARC
   
California employers using CAL-OSHA - regulated carcinogens must register with CAL-OSHA. CAL-OSHA and Federal OSHA carcinogen lists are similar.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE:     None other than the above listed.
 

SECTION VI - REACTIVITY DATA

Stability: Stable.

Incompatibility: None

Hazardous Polymerization: Will not occur.

Conditions to Avoid: None known

 

SECTION VII - SPILL, LEAK AND DISPOSAL PROCEDURES

Spill response procedures (Include employee protection measures):
    Normal clean up precautions of Section VII.

Preparing wastes for disposal (container types, neutralization, etc.):
    May be salvaged for use or removed to a landfill dump in accordance with regulations.
 

SECTION VIII - SPECIAL PROTECTION INFORMATION

Ventilation and engineering controls:
Provide general ventilation and local exhaust ventilation to remove vapor or mist in confined spaces.

Respiratory Protection (type):
NIOSH approved respirator.

Eye Protection (type):
Approved tight-fitting safety goggles or glasses.

Glover (specify material):
Gloves/Rubber.

Other clothing and equipment:   
Clean, body-covering protective clothing, such as long-sleeve shirt with buttoned collar, long pants extending over tops of work shoes.

Work practices, hygienic practices: Keep work area clean to avoid creating excessive dust.

STORAGE & HANDLING:
Storage temperature: Maximum 30C/85F
Minimum 4C/40F
KEEP FROM FREEZING - PRODUCT WILL COAGULATE

Protective measures of contaminated equipment: None other than listed above.

The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use thereof. Multicoat Corporation assumes no responsibility for personal injury or property damage to vendees, users or third parties caused by the material. Such vendees or users assume all risks associated with the use of the material.

back to  MSDS SHEETS


back to Home Page  

please fill out our Feedback Form
to obtain more information

Copyright 2005 Multicoat Corporation.
All rights reserved.